Guide on How to Change Honda Rear Disc Brake Pads

HondaNewsToday. - Here is step by step Guide on How to Change Honda Rear Disc Brake Pads for your Honda car as follow:

Source: www.wikihow.com

1. Drain some of the brake fluid out of master brake cylinder with a suction gun.
2. Loosen the lug nuts on one of your rear tires with a lug wrench.
3. Use a jack to lift your Honda vehicle's rear wheels off the ground.
4. Remove the rear tire and set it aside. 
5. Unscrew your caliper bolts with a torque bit or Alan key that fits over the screws.
6. Slide the brake pads and shims off the caliper.
7. Inspect the rotor for cracks and grooves.
8. Rub disc brake lubricant on the shims and the backs of the new brake pads and attach the shims to the pads.
9. Turn the caliper piston clockwise so it goes back into the cylinder until the groove on the piston lines up with a tab on the inner brake pad.
10. Apply silicon grease to the piston boot and fasten new retainers to the caliper bracket.
11. Install the brake pad assembly and attach the bracket to the caliper. 
12. Replace the wheel and tighten the lug nuts in a star pattern. 
13. Lower the vehicle and pump the brakes to help the new pads into position.

The original article : "How to Change Honda Rear Disc Brake Pads"

Thank you for your coming here in Honda News Today blog, we hope the article above will help you to know more about your information in developing of Honda Inc and other in this time. Please comment here when you want to share and other. Thank you.

And we hope this article will useful to you to get more information in automotive software now that will help you to diagnose and repairing your car and if you give me building comment that you can write on comment form below. See you next time with our recent article again.